Yakima Q103 Manual De Instrucciones

This Yakima application is a little different than the Q clips referred to in your
Q Tower instructions. The M2 measurement (front bar) and M4 measurement
(rear bar) are not necessary because these vehicles have mounting posts
installed by the car maker and are not adjustable.
Before you begin—
Find the mounting posts under the
rubber trim on your vehicle. The
front and rear posts are located
approximately 6 and 36 inches
from your windshield, respectively.
Attach towers to front
and rear crossbars
using the M1 and M3
measurements listed
below.
Follow steps 1–6 in
your Q Tower
instructions.
YEAR MAKE/MODEL
99-04 VW Golf/GTI 2dr
99-04 VW Golf 4dr
99-04 VW Jetta 4dr
NOTE: Follow the Q-34 instructions for rear clips.
Install Clips. Follow steps 9 and 10 in
your Q Tower instructions.
Slide Clip Tower
assemblies down
onto the posts as
pictured.
Remove Rack when not in use to prevent damage to the internal door trim.
TIGHTEN and TEST each Tower as directed in steps 11-15 in the Q Tower instructions.
1031978D - 1/3
103
M1
and
M3
M1 (front) M3 (rear)
35-1/4" NOTE
35" 32-1/4"
35-1/4" 32-1/2"
Slide Clip Tower
assemblies FORWARD
until they stop.
Repeat steps 4 and 5 on
other 3 Towers.
With car doors open, gently place front
bar assembly over front mounting posts
and rear bar assembly over rear
mounting posts.
Center racks so the distance from door
frame to Tower base is equal on both
sides of car.
Pull back rubber trim to reveal a pair
of front mounting posts.
FRONT of car
Q103
A
Part #1031978 Rev.D