Srel2.Cover1; Installation Instructions - Simons Voss Technologies SREL2.COVER1 Instrucciones De Montaje

Srel2.COVer1.

Protective housing for Smartrelay2 for use outdoors.
Suitable for all Srel2.W housing and SC.m.e.W (.WP).

InStallatIOn InStruCtIOnS.

1. Safety screws (spanner head) already inserted/pre-fitted into inlay
2. remove inlay from Srel2.COVer1
3. install the base plate on level ground --> the pierced holes in the
base plate must face downwards – suitable for removing the inlay
from Srel2.W / SC.m.e.W (.WP)
4. fasten Srel2 / SC.m.e.W (.WP) into place (hexagon socket head
screws, din 912, m4 x 8 mm) and install electrical connections
5. Place the inlay of the Srel2.W / SC.m.e.W (.WP) into position
6. Place inlay of the Srel2.COVer1 into position and insert and tighten
safety screws gently press the inlay against the seal on the base
plate to make it easier to tighten the screws. if the inlay needs to be
removed again, undo the safety screws but do not remove them from
the inlay completely --> this makes it easy to re-install the inlay
8