Electrical Connection - DeLonghi HBP742T Instrucciones De Uso

HBP 20-06-2000 15:43
GB

ELECTRICAL CONNECTION

- Before plugging in the heater, check that the voltage of your domestic supply corresponds
to the voltage (V) indicated on the appliance.
- Check that the electrical socket has a rating of 10/16 Amps.
- THIS APPLIANCE CONFORMS TO DIRECTIVE EN 55014 GOVERNING RADIO INTERFE-
RENCE.
INSTALLATION
- Fix bracket to wall, complying with minimum measurement specified in fig. 1.
- Remove appliance from stand, by first turning black locking screw on top of stand 1/4
turn.
- Mount appliance on bracket and lock into place by turning black screw on top of bracket
(1/4 turn).
- Should appliance be installed in a bathroom, it must be mounted on the wall outside the
"safety area", as shown in fig. 2.
- Only use appliance when fixed to a wall or mounted on its stand.
SWITCHING ON AND OFF PROCEDURE
To switch on appliance, whatever the function desired, put timer lever to position
nuous operation, or to position
To switch off appliance, put timer lever to "0".
SELECTOR KNOB
- Position A: Setting for hair dryer function
- Position B: Setting for hair dryer function + Heating at 1000 W without thermostat
- Position C: Heating at 1000 W without thermostat
- Position D: Heating at 2000 W with thermostat on maximum
- Position E: Anti-freeze function (appliance maintains room temperature at about 5°C, pre-
venting freezing with minimum energy consumption).
THERMOSTAT REGULATION
To regulate room temperature, proceed as follows:
- Put selector knob to position D;
- Wait for room temperature to reach comfort level desired, then slowly rotate selector knob
clockwise until warning light goes off.
The temperature thus set will be automatically maintained by the thermostat. Should further
temperature adjustment changes be required, turn knob clockwise to lower the temperature
and counter clockwise to raise it.
TIMER
For programmed function, appliance must be constantly connected to power supply.
For "programmed" heating, proceed as follows:
- For example, if time is 6 p.m., turn numbered dial of timer clockwise until number 18 is
aligned with pointer
- Set desired operating times by pushing inwards red teeth (fig. 4).
- Put timer lever to position
- To change programmed operating times, just push teeth back to original position and
reset timer for new functioning period.
- For use of appliance, outside preset timer programme, just put timer lever to position
HAIR DRYER
Put timer lever to
Hair dryer works at 500 W with switch on handle set on position I ; at 1000 W on position
II .
4
Pagina 4
for "programmed" operation (see Timer section).
on timer.
. Appliance is now programmed to function automatically.
and selector knob to position A (also B = dual function).
for conti-
.