Electrical Connection - DeLonghi Argento HVR9030 Instrucciones De Uso

GB

ELECTRICAL CONNECTION

- Before using the appliance check that your supply voltage is the same of that shown on the
rating label of the unit.
- THIS APPLIANCE CONFORMS TO DIRECTIVE 89/336/CEE GOVERNING RADIO INTERFE-
RENCE.
INSTALLATION
The appliance can be used as a portable unit only, resting on any horizontal surface.
The appliance must not be positioned directly underneath a fixed power point.
OPERATION
- Summer use (ventilation only): turn the knob clockwise to the
- Heating at low power: turn the knob to the 1 position. The pilot lamp switches on.
- Heating at maximum power: turn the knob to the 2 position.
- Setting the thermostat: when the room temperature has reached the desired level, slowly turn the ther-
mostat dial counter-clockwise until the pilot light goes out but no further. The thermostat will now auto-
matically maintain the temperature at the desired level.
- Anti-freeze function
With the knob of the thermostat in position
about 5°C, thus preventing freezing with a minimal expenditure of energy.
- Switching the heater off: turn the knob fully counter-clockwise to the "O" position.
To direct the air flow in the required direction, tilt the appliance manually to one of the two available
positions, 1 or 2 (see fig. 2/3).
MAINTENANCE
- Always unplug the appliance before cleaning the heater.
-
During the season when the appliance is in use, clean the air intake and outlet grille regu-
larly.
- Do not use abrasive cleaning products or solvents.
CAUTION
- Do not make use of this heater in the immediate proximity of showers, bathrubs, swimming
pools, etc.
- Always use the heater in an upright position.
- Do not use the heater to dry your laundry. Never obstruct the intake and outlet grilles (dan-
ger of overheating).
- The heater must positioned at least 50 cm from furniture or other objects.
- Do not use the appliance near walls, furniture, curtains, etc.
- If the power cable is damaged, it must be replaced by the manufacturer, an authorised servi-
ce centre or a qualified electrician in order to eliminate all risk.
- Do not cover the appliance when in operation as this could cause a fire risk.
- Do not use the appliance in rooms less than 4 m
The heater is fitted with a safety device which will switch off the heater in case of accidental
overheating (eg. obstruction of air intake and outlet grilles, motor turning slowly or not at all). To
reset, disconnect the plug from the power for a few minutes, remove the cause of overheating
then plug the appliance in again.
Warning: in order to avoid overheating, do not cover the heater.
position.
, the appliance maintains the room at a temperature of
in area.
2
4