Hog Slat AccuCrank Instrucciones De Montaje página 7

Finishing Feeder AccuCrank™
Step #6
Insert the side panels (F) into feeder. When you insert the side panel into the feeder, it will be
situated behind the feeder door. Line up all the bolt holes for the side panel to attach to the end
panel. Use all 1/4" X 1/2" bolts (Item 1), ¼" flat washers (Item 3), and locknuts (Item 5). The very
top hole on the feeder side where it attaches to the end panel should be installed with the 1/4" X
1/2" bolt, 1/4" flat washer, and locknut on the top. Tighten all bolts.
Hog Slat Inc. Newton Grove, NC USA August 2016 7