Programming - Jura Claris Guia Al Uso Y A La Instalación

5. Programming

5.1 Setting the filter capacity in litre
Please follow the capacity instruction for the appropriate CLARIS filter cartridge (see CLARIS filter Guide).
Step Button
1.
2.
3.
4.
5.
6.
7.
5.2 Resetting the filter capacity (after replacement of filter cartridge)
Step Button
1.
2.
3.
5.3 Memory Access
There is a possibility to individually retrieve the operating data (volume in litre and operation time in month) of the last
five filter cartridges installed.
Step Button
1.
2.
3.
4.
5.
Press the „PROG" button once - „PROG" flashes
Press the „RESET" button once – active digit flashes
By pressing the „RESET" button, set the desired value
- For the digit "2", press "RESET" two times
Press the „PROG" button once to confirm the desired digit and switch to
the next digit. - Active digit flashes
By pressing the „RESET" button, set the desired value
- For the digit „6", press „RESET" six times
Repeat Steps 4 and 5 until all digits have been set
Press the „PROG" button once
- Final filter capacity is set - the programmed value appears
- Display flashes
Programmed filter capacity exhausted or maximum operation time of 12
months exceeded
Press and hold the „RESET" button for approx. 3 sec.
- „rESEt" appears on the display
The filter capacity is reset and the last programmed value appears
Press and hold the „PROG" button for approx. 5 sec.
- The digit „1" appears
The display indicates the volume in litres and the operation
time in months of the last cartridge in place
Press the „RESET" button once
- The operating data of the next to last filter cartridge are
displayed
Repeat Step 3 to access to the memories of the prior installed
filter cartridges
Press the „PROG" button once
- The current filter capacity is displayed
10
Display
Display
Display