Water Filtration System - Sears Kenmore 106.5002 Manual De Uso Y Cuidado

A. Ice guide
IMPORTANT: You do not need to apply a lot of pressure to
the lever in order to activate the ice dispenser. Pressing hard
will not make the ice dispense faster or in greater quantities.
3. Remove the glass to stop dispensing.
NOTE: Ice may continue to dispense for several seconds
after removing the glass. The dispenser may continue to
make noise for a few seconds after dispensing.
The Dispenser Light
On some models, the dispenser light will automatically turn on
when you use the dispenser.
If you want the light to be on continuously, press the
LIGHT ON button. To turn the light back off, press the
LIGHT OFF button.
The dispenser lights are LEDs that cannot be changed. If it
appears that your dispenser lights are not working, see "Problem
Solver" for more information.
The Dispenser Lock
The dispenser can be turned off for easy cleaning or to avoid
unintentional dispensing by small children and pets.
NOTE: The lock feature does not shut off power to the
refrigerator, to the ice maker, or to the dispenser light. It simply
deactivates the dispenser lever. To turn off the ice maker, see
"Ice Maker and Storage Bin."
Style 1:
Style 2:
To lock the dispenser, press the LOCK button. To unlock the
dispenser, press the UNLOCK button.
A
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Water Filter Status Light (on some models)
The filter status light will help you know when to change your
water filter.
The light will change from green to yellow. This tells you that
it is almost time to change the filter.
It is recommended that you replace the filter when the status
light changes to red OR water flow to your water dispenser
or ice maker decreases noticeably.
NOTE: The filter should be replaced at least every 6 months
depending on your water quality and usage.
Resetting the Filter Status
The reset button is located on the control panel in the
refrigerator compartment. To reset the status light after
changing the filter, press the button 5 times within
10 seconds.
The status light will change from red to green when the
system is reset.
Non-Indicator Water Filter (on some models)
If your refrigerator does not have the water filter status light,
you should change the water filter cartridge at least every
6 months depending on your water quality and usage. If the
water flow to the water dispenser or ice maker decreases
noticeably before 6 months have passed, replace the water
filter more often.
Style 1:
Style 2:

Water Filtration System

15