Check that the blade guard can be moved
freely and that the closure mechanism works
correctly before use. Do not use the saw if
this is not the case.
Never use the guards to carry or lift the saw.
Never allow the blade to be in contact with
the item to be cut – or other objects – when
starting up the saw.
Check that there are no nails, screws or other
objects that could damage the blade in the
item to be cut, and that there are no similar
obstructions in the surface beneath the item.
Secure round objects to be sawn using
clamps or similar, as the rotation of the blade
may cause them to spin.
Do not use for routing or milling unless the
appropriate guards are � tted above the
bench, and never use for notching.
Replace the bench inlay once it is worn.
Illustrations
Please refer to the illustrations at the back of
these user instructions.
Main components
1.
Saw bench
2.
Blade guard
3.
Push stick
4.
Saw blade
5.
Cleaver blade
6.
Bench inlay
7.
Parallel guide
8.
Handwheel
9.
Adjustment and lock knob
10. Frame
11. On/off button
12. Lock knob
13. Rubber foot
14. Mitre guide
15. Screw
16. Dust extractor nozzle
17. Recessed screw
18. Hole in cleaver blade
19. Assembly screw
20. Screw
21. Groove
22. Measurement scale
23. Rail
24. Holder
25. Groove
26. Wing nut
27. Groove
28. Front rail
29. Leg
30. Short cross brace
31. Long cross brace
32. Support
32a. Bracket
33. Bench extension
34. Tool hook
35. Spanners
36. Dust extractor hose
A.
Rollover bracket
B.
Overload protection
a.
Screw
b.
Hex screw
c.
Nut
GB
33