GYS 053854 Manual De Instrucciones página 5

Translation of the original instructions
INSTRUCTION TO CHANGE THE FABRIC OF THE GLOVE INDUCTOR
1. Delicately cut the Silicone which maintains the
fabric closed and in position.
Be careful not to alter the insulation of the inductor
cable.
2. Remove the inductor block.
3. After removing the inductor block, check that the
insulation is not impaired otherwise change complete
inductor.
INDUCTORS PROTECTION
4. Slide the inductor block into the new fabric.
Pay attention to the right direction, the magnetic pro-
tection plate on the velcro side.
5. Check that the inductor is pushed all the way down.
6. Close up using the glue supplied.
7. Hold in place with clamps for 24h.
EN
5