Publicidad
Idiomas disponibles
Idiomas disponibles
English
(4) holes located on either side of its front flange, as shown above.
1. Prepare the wall
A. Find wall stud locations on desired wall and mark edg-
es of the studs.
B. Locate unit height where control can be reached.
2. Mark desired location
A. Mark hole locations for the TTW EasyMount™ sleeve.
Both sides of the wall should be marked for 14½"W x
16¼"H (36.8 x 41.3cm) .
3. Cut hole in wall
A. Cut hole 14½"W x 16¼"H (36.8 by 41.3cm) inside of
stud to inside of stud.
4. Insert installation sleeve (inside wall-mount sleeve)
Slide EasyMount Sleeve into opening so that flange
A.
area is flush with finished surface of wall. Mount flange to
the side of the wall where the face of the TTW unit will be
flush.
B. Ensure EasyMount™ sleeve is level and square. Shim
bottom and sides as needed.
. Fasten sleeve to wall
5
Insert screws into upper pre-drilled hole on both sides of
A.
sleeve, continue to lower set of holes. Ensure screws are
flush with wall sleeve. Do not over tighten.
New Design EasyMount™ Sleeve
The new design EasyMount™ sleeve is fastened through four
6. Slide unit through installation sleeve
Slide the Wine Guardian Through-the-Wall system
A.
through the Easy Mount™ sleeve. Insert the end of the unit
that does not have the power cord attached to it into the
sleeve. Then slide the unit into the sleeve until desired
depth. Make sure power cord is kept clear of the sleeve.
4
Publicidad
