CEMO PE Manual De Instrucciones página 4

GB
Content
1. General
2. Technical data
3. Commissioning
4. Environmental factors
5. Accessories / Spare parts
6. Maintenance
7. Warranty
4
1. General
The proper intended use for the PE boot cleaner
is to clean dirty footwear (boots).
The maximum water temperature may not exceed
40 °C.
2. Technical data
Dimensions L x W x H: 52 x 47 x 90 cm
Weight: 15 kg
Connector for ½ in hose
1 ½" threaded outlet
3 stationery brushes
1 mobile hand brush
Stainless steel lines
Integrated hand grip
3. Commissioning
The PE boot cleaner should be installed on a
level, non-slip surface.
Connection is via a water hose that fastens to the
½" hose sleeve with a hose clamp.
The water flow to the brushes and hand brush
can be regulated separately via their ball valves.
Water is applied to the brushes at an angle from
above, through 3 holes on each side.
Waste water is discharged on the left (1 ½" outlet)
The soles and sides of boots can be cleaned
using the 3 stationery brushes.
The mobile hand brush can also be used to clean
boot legs.
The water flow to the mobile hand brush can be
modified by turning the orange handle component
on the hand brush itself.
As shown in the picture, the brush can be hung
up.