CEMO PE Manual De Instrucciones página 5

Flow regulation
Pay attention to adopting a stable position during
use, and make use of the integrated hand grip.
4. Environmental factors
The PE boot cleaner should not be exposed to
direct sunlight for extended periods.
Excessive heating can result in deformation of the
high-grade plastic housing.
Suitable usage conditions are max. -10 °C to
+40 °C.
If there is a risk of frost, disconnect the boot
cleaner from the water supply, and empty it.
5. Accessories / Spare parts
Replacement brush set
for stationery brushes (3 pieces)
Item. No. 232.0009.011
Replacement brush set
for mobile hand brush
Item. No. 232.0009.005
Non-slip matt 60x80 cm
Order No. 10166
Non-slip matt 80x120 cm
Order No. 10167
6. Maintenance
Dirt on the inner walls can be washed away using
the hand brush.
Check that hose clamps are firmly in place.
Worn brushes can be removed and replaced via
the four screws on each brush.
7. Warranty
Under our general terms and conditions of trade
we warrant that the PE boot cleaner will be produ-
ced free from defects in materials, functionality or
workmanship. These are available at
http://cemo.de/agb.html
The warranty applies only under the condition
that the above operating instructions, and all
applicable regulations, are closely followed.
GB
5