Residual Risks - DeWalt D21585 Traducido De Las Instrucciones Originales

english
Additional Safety Instructions for
water supplied Drills
• Before use check the drill core bits. Never
use damaged or deformed core bits.
• Use only drill core bits which are designed
and recommended for this machine. Always
consider the minimum and maximum
diameter and the length given in the technical
data.
• Always use hearing protection to reduce the
risk of induced hearing loss.
• Wear safety goggles or other eye
protection. Drilling operations cause chips to
fly. Flying particles can cause permanent eye
damage.
• Wear gloves when handling core bits or
rough material to reduce injuries by sharp
edges.
• Use non-slipping footwear to prevent injuries
by slippery surfaces.
• Drilling with stand is only allowed downwards
or horizontal. The stand shall be fixed, either
by bolts (e.g. D215825) or vacuum fixation.
• Check the surface where the drill stand shall
be fixed. Rough surface can significantly
reduce the effectiveness of the suction
system. Coated or laminated surface can be
pulled off during work.
• Control the minimum vacuum level before
and during drilling operation when using
vacuum pump. The minimum level shall not
be less 650 mbar.
• For safe operation and vacuum fixation the
diameter of the drill core bit shall not be
greater than 82 mm.
WET DRILLING
• Always use a water cooling device and a
water collection system.
• Always use core bits designed for wet drilling.
• The maximum water pressure is 3 bar. Use
a pressure relieve valve in case of a higher
water pressure.
• Use only pure tap water for cooling
purposes.
• Prevent water from entering the motor or
other electrical components. Make sure the
PRCD is not in contact with water.
WARNING: We recommend the use of
a residual current device with a residual
current rating of 30mA or less.
26

Residual Risks

In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
– Impairment of hearing
– Risk of personal injury due flying particles.
– Risk of burns due to accessories becoming hot
during operation.
– Risk of personal injury due to prolonged use.
The following factors increase the risk of breathing
problems:
– No dust extractor connected when performing
dry operation
– Insufficient dust extraction caused by uncleand
exhaust filters
Markings on Tool
The following pictograms are shown on the tool:
Safe use warning
Read instruction manual
before use.
Wear ear protection.
Wear eye protection.
Always wear a dust mask
Always wear safety shoes
Always wear safety gloves.
Water supply
Gear selection
Applications in masonry
Applications in concrete
When using the machine, make sure
that the machine is mounted on a stand.
Never use the machine handheld, as it
will lead to loss of control and serious
injury.