Listen To Radio; General Operation - CTC BR 816 Manual De Instrucciones

Power Supply
1. Make sure the grid voltage corresponds to the figures on
the rating plate.
2. Flap the rubber cover down.
3. Plug the power supply unit into a properly installed protec­
tive contact socket.
4. Connect the device with the plug connector by inserting
its plug into the "6 V DC IN" jack of the device.
CAUTION:
• Only use the supplied power adaptor for this device. Do
not use for other devices.
• Only use power adaptor with 6 V (
tors may cause damage to the device.
NOTE:
Disconnect from mains power supply during longer periods
of non­use.
Insert the Batteries (batteries not supplied)
1. Open the battery compartment (10) at the rear, loosen the
screw with a screw driver.
2. Insert 4 batteries type UM 2 / R 14 1.5 V. Observe correct
polarity (see battery compartment)!
3. Close the battery compartment and tighten the screw.
NOTE:
• Battery operation is automatically deactivated after
connecting the power adaptor.
• Exchange the batteries as soon as the brightness of the
status indicator POWER (5) decreases.
WARNING:
The batteries shall not be exposed to excessive heat such
as sunshine, fire or the like. Danger of explosion!
CAUTION:
• Batteries can leak battery acid. If the device is out of use
for a long period of time, remove the batteries.
• Different battery types or new and used batteries must
not be used together.
• Batteries are not to be disposed of together with domes­
tic wastes. Dispose of the used batteries at the relevant
collection bin or at your dealer's.

General Operation

Turn Unit Off
The unit is turned off by setting the function selector (3) to
OFF Position.
Volume
Turn the VOLUME knob (1) to set the desired volume.
BR816_IM_CTC_new
AUX-IN Socket
Connect analog playback devices here. Listen to connected
devices, such as MP3 players, CD players, etc.
1. Flap the rubber cover down.
2. Connect the external device via 3.5 mm stereo jack to
AUX­IN (8).
3. Set the function selector (3) to FM or AM position. The
unit automatically turns to AUX­IN operation. The radio
sound is muted.
4. The unit plays the sound from the connected external
device. Turn the VOLUME knob (1) to set the desired
volume.
), other adap­
5. Operate your external device as described in its user
manual.
NOTE:
Set the volume of the external device to an appropriate
level.
1. Set the function selector (3) to select the desired fre­
quency band.
2. Turn the frequency selector (6) to tune into your favourite
station. The upper dial scale shows the FM frequencies.
The lower dial scale shows the AM frequencies.
• The flexible antenna (7) receives FM stations.
• The AM antenna is integrated in the unit. Turn the unit for
best reception. This frequency band broadcasts programs
in mono only.
CAUTION:
• Do not immerse the device in water.
• Do not use a wire brush or other abrasive objects.
• Do not use any caustic or abrasive cleaning agents.
• Remove the plug before cleaning.
• Clean the appliance with a slightly humid cloth without any
additives.
Problem
The unit does
not work.

Listen to Radio

VHF = FM, Medium Wave = AM (Mono)
Cleaning
Troubleshooting
Cause Solution
The unit is Disconnect the mains
blocked and plug for approximately
"hangs". 5 seconds. Then
switch the unit back
on.
21
23.05.17