BeeWi BBZ351 Guia Del Usuario página 7

7
3. USING THE HELICOPTER
3.1. Connection
If it has been previously paired, the Helicopter will automatically connect
to the iPhone when it is powered on.If this is not the case, you can also
go to the iPhone Bluetooth menu and select the "BeeWi BBZ351" device
in your device list. Once the status is "Connected", close the Bluetooth
menu and get back to the main screen.
If you are using 2 different helicopters with the same device, always
make sure there is only one connected at a time or the application will
malfunction.
3.2. Operation
Upon connection, the BeeWi HeliPad
application will open automatically. If it
is not the case, you can always launch it
from the phone app screen.
The Helicopter will be connected
automatically and the control screen
below displayed. By default the control
is motion and the trimmer is set to "0".
Gently push the throttle until the
Helicopter engine turns one. Then keep
the Helicopter on the ground and try the direction commands to learn
how to fly:
- To move forward, move the mobile device downwards
- To move backward, move the mobile device upwards
- To turn left, turn the mobile device leftwards
- To turn right, turn the mobile device rightwards
If the helicopter is drifting during the initial trial on the ground, it may
be necessary to adjust the direction trimmer. To do so, you need to slide
down the SETTINGS bar and trim left or right:
- If the helicopter is drifting on the left, adjust the direction using the
Trimmer + key
ENGLISH