Using The Pump - Uline H-4896 Instrucciones

7. Insert the pump tube through
the bottom piece on the
lid. Push the pump into the
container until it hits the
bottom, sliding the O-ring up
the tube as you go.
(See Figure 7)
8. Once the pump is in place, slide the O-ring down
until it meets the topmost part of the bottom piece,
then tighten the top adapter onto the bottom piece.

USING THE PUMP

For best results, your pumping method will need to vary
for the quantity of liquid required and for the viscosity of
liquid being pumped.
With more viscous liquids, slow and steady strokes are
the best. If you require an exact amount of liquid, use
shorter strokes as you near the quantity of liquid required.
The outlet nozzle swivels and can be turned up to prevent
any dripping, especially when pumping viscous liquids.
WARNING! Never use the pump when the outlet
nozzle is pointing up.
1
3
4
5
6
10
2
7
8
PAGE 2 OF 6
INSTRUCTIONS CONTINUED
O-Ring
# DESCRIPTION
9
1 Ball Handle
2 Plunger
3 Pumphead Cap
Seal Pack, Includes: 4, 5
4 Pumphead Scraper Seal
11
5 Pumphead Seal
6 Pumphead Seal Holder
Plunger Valve, Includes: 7, 8
7 Plunger Valve Flap
14
8 Plunger Valve Holder
15
9 Safety Strap (White)
10 Pump Body 200/55PP
11 Outlet Nozzle
Foot Valve, Includes: 12, 13
12 Foot Valve Flap
13 Foot Valve Holder
12
14 2⁄" Pail Adapter
13
15 O-Ring
70mm Cap Adapter (Not Shown)
UNLOCKING THE SAFETY STRAP
Figure 7
Place a hand across the breadth of the
safety strap and squeeze. (See Figure 8)
This action will raise the locking spigot
and allow the safety strap to fold down.
NOTE: Always replace the safety
strap after using the pump.
REMOVAL AND CLEANING
1. Remove the pump and hold the outlet nozzle over
a container or bucket and tip slowly backward and
forward until the flow stops.
2. When the pump has been used to pump water–
soluble liquids, rinse the pump by standing it in a
bucket of water and pump until empty.
WARNING! Respect the toxicity of any chemical
being pumped. Read the product label for
advice on necessary eye, skin and inhalation
protection and protective clothing. Remember,
the pump will have a quantity of chemical
contained inside it when it is removed.
PARTS
1-800-295-5510
uline.com
ULINE PART NO. MFG. PART NO.
-----------
----------- -----------
----------- Y0366
H-1553-SEAL SP_LDPE
----------- Y0376
----------- Y0375
----------- Y0362
H-1553-PLUNG
----------- Y0358
----------- Y0360
----------- Y0353
----------- -----------
----------- Y3037
H-1553-VALVE
----------- Y0359
----------- Y0361
H-4896-ADAPT
----------- -----------
H-4896-CAPAD
Figure 8
HW
VP
VF
PSA
C69
0721 IH-4896