Ferm HAM1017P Traducción Del Manual Original página 5

• Check if the mains switch is on position "0"
before you connect the apparatus;
• Keep the main lead always away from the hot
air stream and the mouth piece;
When the temperature is excess 600° C, the heats
switches it off automatically, however, the heater
continues to run. When the heater has cooled to
operating temperature, the heater is switched on
again.
Switching off:
Slide the switch to 0.
Tip: If you want to get the best result, test all
appliances on a little part of the workpiece.
4. MAINTENANCE
Always disconnect the apparatus before
carrying out inspection or cleaning.
Never use water or other liquids to clean
the electrical parts of the hot air gun.
• Never use easy inflammable liquids for cleaning
the hot air gun, especially for the mouthpiece.
• Regular maintenance of your hot air gun
prevents unnecessary problems. Keep the
ventilation slots of the hot air gun clean to
prevent overheating.
Troubleshooting
In case the hot air gun does not work well, we give
you subjoined some possible causes and their
solutions.
• The engine gets overheated.
• The ventilation slots of the hot air gun are dirty.
• Clean the ventilation slots.
• The hot air gun does not start when it is
switched on.
• Interruption in the electrical circuit.
• Check the mains lead and the mains plug.
• The switch is defective.
• Pull the mains lead out of the wall socket,
because there is a chance of fire risk ! Have
the hot air gun repaired at your local dealer.
• The engine does not work, but it does heat.
• Interruption in the electrical circuit.
• Pull the mains lead out of the wall socket,
because there is a chance of fire risk ! Have
the hot air gun repaired at your local dealer.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. In the back of this manual you find
an exploded view showing the parts that can be
ordered.
GUARANTEE
The guarantee conditions can be found on the
separately enclosed guarantee card.
ENVIRONMENT
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
5