Attaching The Blades To The Blade Brackets - HAMPTON BAY 91850 Guía De Uso Y Mantenimiento

Assembly - Attaching the Fan Blades (continued)
2
Attaching the blades to the blade
brackets
NOTE: Your fan blades are reversible. Select the blade side
finish which best accentuates your decor.
□
Mount the fan blade (F) to the blade bracket (G) by aligning the
three key-slot holes in the blade (F) with the three posts on the
top of the blade bracket (G).
□
Hold the blade (F) with both hands close to the blade bracket
(G) and press down firmly. Ensure the key-slot holes are prop-
erly seated on the blade bracket (G) posts.
□
While still holding the blade (F) down with both hands, slide
the blade (F) until it engages in the locking mechanism (UU).
Make sure the locking mechanism (UU) at the rear of the blade
bracket (G) springs upward and butts against the edge of the
blade (F), indicating a secure connection.
□
Visually inspect the top of the blade bracket (G) to ensure the
locking mechanism is securely in place.
□
Repeat this procedure for the remaining blades (F).
Assembly - Attaching the Lights
1
Attaching the light kit fitter assembly
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light fixture.
NOTE: Notice the location of the fan's slide switch. This is the
switch used to change the fan's directional rotation. For more
information on the operation of this switch, see Operating
Your Fan on page 13.
□
Remove the three screws (VV) on the switch cup cover of the
light kit fitter assembly (E).
□
Connect the wires from the light kit fitter assembly (E) to the
wires from the switch cup of the fan-motor assembly (D) by
connecting the molded adaptor plugs together (blue to black,
white to white). Carefully tuck all wires and splices into the
switch cup.
□
Align the three holes in the switch cup cover of the light kit
fitter assembly (E) with the three holes in the switch cup
of the fan-motor assembly (D). Make sure the notch in the
switch cup cover of the light kit fitter assembly (E) clears the
reversing switch in the switch cup of the fan-motor assembly
(D). Position the light kit fitter assembly (E) and re-install the
three screws (V V) that were removed in first step to secure
the light kit fitter assembly (E).
UU
VV
11
Please contact 1-855-HD-HAMPTON for further assistance.
D
G F
D
E
HAMPTONBAY.COM