Publicidad
Idiomas disponibles
Idiomas disponibles
• Connect the Gray/Black wire to the radio's right front negative
speaker output.
• Connect the purple wire to the right rear positive speaker output.
• Connect the purple/Black wire to the radio's right rear negative
speaker output.
installinG the Gmrc-04
• With all connections completed to the aftermarket radio, plug the 32-pin
harness into the vehicles wiring harness.
• Cycle the key by turning the ignition on for 30 seconds. Then off and on again
to test the radio.
• Mount the GMRC-04 in a location where the internal speaker will be heard.
METRA. The World's best kits.
GMRC-04
™
1-800-221-0932
Note: If the chime volume of the GMRC-04 is too loud you will need to remove the cover and
cut the solder connection where the arrow points to on the circuit board (between the holes
on the board).
K
P
NOWLEDGE IS
OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
metraonline.com
Cut for low volume
Caution: Metra recommends disconnecting the
negative battery terminal before beginning any
installation. All accessories, switches, and especially
air bag indicator lights must be plugged in before
reconnecting the battery or cycling the ignition.
Note: Refer to the instructions included with the
aftermarket radio.
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
Publicidad
