EGO PTX5100 Manual Del Usuario página 26

Follow the steps below to fill with the grease:
1. Switch off the tool and remove the battery pack.
2. Use a hex wrench (not included) to loosen and remove 3 short screws on the
motor cover and then detach the motor cover (Fig. 15).
15
Planet Gears
NOTE:
After removing the motor cover, clean up the sawdust around the motor.
3. Loosen the 3 short screws on the motor and then detach the motor and the
washer.
4. Use a grease gun (not included) to inject maximum 0.01 lb. (5g) grease at the
center of the 3 upper planet gears into the gear case.
NOTE:
Ensure that the position of other parts near the gear case remains unchanged
during injection.
5. Reassemble the washer and the motor by tightening the 3 short screws.
6. Reassemble the motor cover by tightening the 3 short screws.
26
HEDGE TRIMMER ATTACHMENT — PTX5100/PTX5100-FC
Short Screw
Motor Cover
Short Screw
Motor
Washer
Gear Case