Installation Steps - LUND Interceptor Instrucciones De Instalación

Installation Steps

3
Use a pen to indicate the four (4) locations where the holes in hood shield align on the hood.
4
Carefully set hood shield aside. Use a hammer and center punch to mark the points made in Step 5 in prepara-
#16
tion for drilling. Carefully use a drill fitted with a #16 bit (.177" / 4.5mm) and a stop collar to drill a 1/8" (3mm)
.177"
4.5 mm
5
Reposition hood shield on hood edge, aligning the holes in the hood shield with the holes drilled in Step 6. Insert a
6
NOTE: Actual application may vary slightly from illustrations.
Carefully center hood shield on hood edge.
X4
hole in the hood. After drilling, apply an anti corrosion agent to the hole. Repeat for remaining holes.
X4
screw through each hole and secure hood shield to hood. NOTE: DO NOT OVERTIGHTEN.
#16
.177"
4.5 mm
CAUTION: DO NOT PUSH SCREW
THROUGH TO THE OPPOSITE SIDE
X4
Page 2 of 3
CAUTION: DO NOT DRILL
THROUGH HOOD TO OPPOSITE
SIDE.
1/8"
3 mm
OF THE HOOD.