Problems And Solutions - Mestra 100195 Manual Original

PROBLEMS AND SOLUTIONS

Problem
The front panel switches do not
tum on.
There is insufficient or no team
output.
Boiling water jumps when I fill
it.
When turn on the steam switch,
it does not work and the lamp
does not turn on.
There is enough water in the
tank, but the "No Water " lamp
is still on.
The water tank cap is tightly
closed, but steam is still leaking.
The gauge needle shows the
pressure above 5 bar.
The " Steam " lamp turns on and
Off during operation.
Steam always comes out mixed
with water.
Cause
Machine unplugged.
Broken plug.
The water tank is empty.
The boiler switch is off.
The vapor pressure level is low. The hose
is kinked.
Electrical disconnection. In this case, the
valve inside the boiler body does not make
any sound when the button of the
steam gun is pressed.
The boiler is too hot.
Electrical failure.
Electrical failure.
Damaged rubber gasket. Mechanical fail-
ure.
Electrical or mechanical failure.
It is not a problem.
The tank is overfilled.
The proportion of lime and water sediment
in the tank increased.
Solution
Connect the plug correctly. Check the
plug.
Fill the tank.
Tum on the switch (2) and wait until the
"Steam" lamp turns on.
Wait until the steam pressure reaches more
than 1.5 bar.
Check the hose.
Contact an authorized technical service.
Wait a couple of minutes while the lid is
opened to reduce the tank temperature.
Disconnect the appliance from electricity.
Contact an authorized technical service.
Disconnect the appliance from electricity.
Contact an authorized technical service.
Replace the rubber gasket on the plug.
Disconnect the appliance from electricity.
Contact an authorized technical service.
Disconnect the appliance from electricity.
Contact an authorized technical service.
You can keep working.
Drain the excess of water.
Fill the water tank halfway, wipe with wa-
ter and empty it.