Hardware Installation - Vuescape 11009588 Manual Del Usuario Y De Instalación

Hardware Installation

Please note for Windows
Before attaching your new LCD monitor to your computer, please make sure that your resolution and refresh rates are set
correctly for your monitor to work properly. This is especially important if you are changing monitors (for example, from a
CRT to a LCD). Before disconnecting your old monitor, please set the resolution to 1440 x 900 and set the refresh rate to
60Hz. You can adjust these settings by right clicking your desktop, select "Properties", then "Settings". To adjust the
refresh rate, click on "Advanced" and search for this option.
Video card settings will be different based on the video capability of your computer. Please consult your video graphics card
or computer manual for more information.
1.
Carefully position your LCD monitor so that you can see all of the connection ports on the bottom of the monitor.
2.
A.) Plug one end of the 15-pin D-Sub signal cable into the VGA connector
the cable into the 15-pin D-Sub connector at the rear of your PC.
B.) OR if you are using a DVI signal cable (not included) plug one end into the DVI connector
the other end of the cable into the 24-pin DVI connector at the rear of your PC. Make sure that all of the screws are
hand-tightened securely.
3.
Plug the Audio connector to the Audio In port
is optional if you wish to use a different audio source.
4.
Plug the power connector to the AC In port
5.
Connect the power cord to the power source.
6.
Power on the computer and the monitor.
7.
For best quality performance, set the resolution as shown on the Display Mode chart.(see pg. 11).
®
User's
on the monitor, and to the computer line out at the rear of your PC. This
port at the rear of the monitor.
7
on the monitor and plug the other end of
on the monitor and plug