Functions On The Control Panel - METRICA 60719 Manual Del Usuario

2.3 Functions on the Control Panel

– (A) ON OFF - This button controls the power state
– (B) TILT function. After the laser level has started with the
self-levelling, press this button (hold it):
- The red LED flashes
- After 20 seconds the red LED stays on and the TILT function
is enabled. Now, when the laser level is moved, the laser beam
will start to flash and the rotation will stops this means that the
laser is misaligned in relation to the starting position.
– (C) Rotational speed adjustment. The scan speed has 5 mo-
des: 0 – 60 - 120 – 300 – 600 r.p.m.. If this button is pressed
repeatedly, the speed of rotation of the laser module consecu-
tively changes.
– (D) Receiving window of the remote control pulse. After the
laser beam began to rotate some functions can be activated
via remote control, e.g. setting of the slope, the start of the
automatic alignment
– X-direction indicator. When this indicator is turned on, the
plan generated by the rotating laser can be tilted along the
direction X
– Y-direction indicator. When this indicator is turned on, the
plan generated by the rotating laser can be tilted along the
direction Y.
3. GUIDELINES
3.1 Batteries
4 rechargeable batteries OR 4 dry batteries (AA) can be used for
this instrument.
WARNING
– THE TWO TYPES OF BATTERIES CANNOT BE MIXED
– DO NOT CONNECT THE CABLE RECHARGE AND DO NOT PUT
THE INSTRUMENT IN CHARGE WHEN DRY BATTERIES ARE
PLACED INSIDE.
THE INSTRUMENT WOULD BLAST
– ONLY WHEN USING rechargeable batteries the charging
cable can be inserted into the hole on the side of the in-
strument covered by a rubber stopper.
3.1.1 Batteries installment
1. After loosening the screw remove the cover of the batteries
socket on the side of the instrument
2. Insert the batteries according to + and - symbols
3. Replace the cover on the socket and tighten the screw
3.2 Instrument allocation
Place the instrument on the tripod (with a 5/8" thread) or on a
flat surface or hang it on the wall. Place the tool upright and flat
within a range from -5 ° to +5 °
9