done, the yellow light will go out after some time. The shaver's electronics
will then assume it has been cleaned manually and a new calculation of the
time when the next cleaning is required will be started.
Automatic cleaning
Once the shaver is put into the Clean&Renew, it is cleaned automatically
(see «C Clean&Renew»).
Manual cleaning is recommended only when the Clean&Renew is not
available, e. g. when travelling.
Manual cleaning
Regular cleaning ensures better shaving performance. Rinsing the shaver
head under running water after each shave is an easy and fast way to keep
it clean:
• Switch on the shaver (cordless) and rinse the shaver head under hot running
water until all residues have been removed. You may use liquid soap
without abrasive substances. Rinse off all foam and let the shaver run for
a few more seconds.
• Next, switch off the shaver, remove the shaver Foil & Cutter cassette (1)
and let it dry.
• If you regularly clean the shaver under water, then once a week apply
a drop of light machine oil onto the long hair trimmer (2) and shaver
Foil & Cutter cassette (1).
Alternatively, you may clean the shaver using a brush:
• Switch off the shaver. Remove the shaver Foil & Cutter cassette and tap
it out on a flat surface.
• Using a brush, clean the inner area of the shaver head. However, do not
clean the shaver Foil & Cutter cassette with a brush as this may damage it.
Replacement light for shaving parts/Reset
To maintain 100% shaving performance, replace the shaver Foil & Cutter
cassette (1), when the replacement light for shaving parts (8) comes on (after
about 18 months) or when worn.
The replacement light will remind you during the next 7 shaves to replace the
foil and cutter cassette. Then the shaver will automatically reset.
After you have replaced the Foil & Cutter cassette (1), press the on/off switch
(4) for at least 5 seconds to reset the counter.
While doing so, the replacement light blinks and goes off when the reset is
complete. The manual reset can be done at any time.
17