Peavey PV 1 VHF Manual De Instrucciones página 10

• Features the Peavey unidirectional neodymium dynamic cartridge for optimum true
sound, maximum feedback rejection and minimal handling noise
• OFF/ON/STANDBY switch allows convenient audio muting with the transmitter "ON"
• Low battery LED indicator flashes once for unit "ON"; steady illumination signals
low battery
• Choice of instrument headset or lavalier microphone bodypack transmitter
• OFF/STANDBY/ON switch allows convenient audio muting with the transmitter "ON"
• Low battery LED indicator flashes once for unit "ON"; steady illumination signals
low battery
• Locking 3.5mm mini-jack provides secure connection for removable microphone or
instrument cable
• Easily accessible input level adjust control for optimum sound
1. Powering the Receiver
Plug the 12V AC/DC ADAPTER (11) into the DC INPUT JACK (10) on the back of
the receiver. Then plug the power supply into an AC outlet. (Note: Any 12V DC
source with 400mA capability can also be used.) Press the POWER SWITCH (1)
to turn on the receiver. The POWER ON LED will now light and the receiver is
operational.
2. Antennas
The PV1 receiver is supplied with TELESCOPIC ANTENNAS (5). These should
be extended fully to obtain maximum range. Optimal antenna positions are
45 degrees from the receiver (at 90 degrees from each other). For maximum
range, it is always best to maintain a line of sight (no obstructions) between the
receiver antennas and the transmitter at all times whenever possible.
3. Squelch Adjustment
In normal operation, the SqUELCH CONTROL (6) should be set fully
counterclockwise to the factory preset minimum RF level. However, in areas of
high RF activity, the squelch (or mute, as it is sometimes called) may need to be
adjusted to compensate for the adverse conditions in a particular location. If,
with the transmitter off, the receiver's A and/or B DIVERSITY LED INDICATORS
(3) and/or one or more LEDs of the LED RF LEVEL DISPLAY (4) flicker or stay
on, the Squelch control should be turned clockwise until the LEDs extinguish.
When the Squelch is properly adjusted, the A and/or B LEDs or the RF LEVEL
LED displays will only light when the system transmitter is turned on. Turning
the squelch control too far clockwise will reduce the range, but yield a quieter
squelch (mute) function. During operation especially at ranges greater than 75
PV 1 HANDHELD MIC TRANSMITTER
®
PV1 BODYPACK TRANSMITTERS
PV 1 RECEIVER