Peavey PV 1 VHF Manual De Instrucciones página 13

PV 1 HANDHELD MICROPHONE TRANSMITTER
®
1. Unscrew the BATTERY COMPARTMENT COVER (17) and remove, exposing the
BATTERY HOLDER (19). Insert a new 9V ALKALINE BATTERY (18), observing the
correct polarity as marked, and screw the cover back onto the microphone, Make
sure the cover is screwed on completely. A fresh alkaline battery can last up to 16
hours in use, but in order to ensure optimum performance, it is recommended that
you replace the battery after every 10 hours of use.
2. Turn on the PV
position (transmitter on, audio muted) or the ON position (transmitter and audio
both on). The BATTERY INDICATOR LED (21) will give a single quick flash, indicating
usable battery strength. In the case of a dead or low battery, the LED will either
not flash at all or will stay on continuously, indicating that the battery should be
replaced. To preserve battery life, turn the transmitter off when not in use.
3. The microphone is now ready to use. The A and/or B DIVERSITY LED INDICATORS
(3) and most or all of the RF LEVEL DISPLAY LEDs (4) on the PV1 receiver should
now be illuminated, indicating a received signal from the transmitter. When ready
to speak, slide the transmitter switch to the ON position. Adjust the volume of the
receiver as per the Audio Output Microphone Connection section of the above PV1
receiver instruction. The AF LEVEL LED DISPLAY (4) on the PV1 receiver will light up
to five LEDs (four green and one red) for all input signals. Occasional flickering on
and off during use of the top red LED indictor in this display is normal; however, if
the red LED stays on continuously, it means the signal is too loud and there is the
possibility of overload distortion. Back off from the microphone until the red LED
indicator only flickers on peaks.
[Note: Observe care in selecting P.A. volume, transmitter location and speaker
placement so that acoustic feedback will be avoided.]
[Note: Microphone elements can easily be destroyed by the buildup of salts and
minerals from perspiration and saliva. It is good practice to put a windscreen on the
mic element at all times to protect it.]
17. Battery compartment cover
18. 9V battery
19. Battery Holder
20. On/Standby/Off switch
21. Battery indicator LED
17
1 by sliding the OFF/ON/STANDBY SWITCH (20) to the STANDBY
®
18
20
19
21