Troubleshooting - avenli 290717 Manual De Instrucciones

5. Trouble shooting
Problem
Cleaner does not
capture the debris
Garbage flowing out from
the Transparent Suction
Head part
Garbage flow out from the
rear filter bag
Handle/pole connector
cannot be secured in
assembly
Cleaner cannot be recharged
Possible Cause
Battery is running out
Impeller is jammed
Impeller is broken
When the filter bag is
full
The soft rubber of the
rear impeller is broken
Filter sock is damaged
Side pin broken
Battery is dead
The charger is out of
order
Action
Charge the battery again. Normally cleaner
can operate about 60 minutes after fully
charged.
Power off the cleaner and visually check the
gap in middle of the cleaner to see if the
impeller is jammed. you can use your hand
to rotate the impeller two circles to make the
impeller rotation looser.
WARNING! Make sure cleaner is power
off when servicing the cleaner.
Contact your dealer for impeller replacement.
Detach the filter basket and filter bag, and
clean them.
The soft rubber of rear impeller is like a
door in case the garbage in the filter bag will
flow backwards into impeller and the cover
of transparent suction head part.
Replace a new filter sock.
Using the new V-Shape clip
Contact dealer for battery replacement.
WARNING! When you replace the bat-
tery, please contact the local dealers to
purchase the original lithium battery in
case that the electric cleaner is destroyed.
Contact dealer for proper transformer.
WARNING! Using wrong charger will
result in damaging the cleaner /battery
and void the warranty.
5