Care And Cleaning; Troubleshooting - Allen + Roth 21-K151HCORB-AR Manual De Instrucciones

INSTALLATION INSTRUCTIONS (Continued)
7. To install the optional soap dispenser, unscrew the top of the
soap dispenser (D) from the plastic soap bottle and remove the
mounting nut (FF) and rubber gasket (EE). From above the sink,
insert the top of the soap dispenser into the fourth hole opening
in the sink. From underneath the sink, place the rubber
gasket (EE) onto the shank (7.1) on the soap dispenser (D)
and then thread the mounting nut (FF) onto the shank (7.1) to
secure the soap dispenser (D) to the sink.
8. From underneath the sink, screw the plastic soap bottle (8.1) onto
the soap dispenser shank (8.2).

CARE AND CLEANING

Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these
will dull the finish and void your warranty.

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE
Faucet leaks Bonnet has come loose or
underneath handle. o-ring on cartridge is dirty or
twisted.
SOLUTION
1. Move the handle to the OFF position. Unscrew the handle screw and remove
the handle.
2. Tighten the bonnet by turning it clockwise. Move the cartridge stem to the ON
position. The leak should stop draining out from around the cartridge stem.
3. If the leak does not stop, shut off the water supply. Remove the bonnet by
turning it counterclockwise. Lift out the cartridge valve. Inspect the larger
o-ring on the cartridge bonnet and the smaller o-ring on the cartridge stem.
Remove any debris from the o-rings. If either o-ring is twisted, straighten it. If
either o-ring is damaged, replace the cartridge by calling customer service.
4. Position the cartridge back into the faucet body. Make sure the ridges on the
two sides of the cartridge bonnet fit into the grooves on the two sides of the
faucet body. Tightly screw the bonnet onto the faucet body.
5. Reinstall the handle.
6
7
7.1
EE
FF
8
8.2
D
8.1