Publicidad
Montagem dos componentes originais (Versões
Multistrada)
Refitting the tank
Volte a montar o painel insonorizado (T1) e a calota insonorizada
(T2) na moto.
Reposition the tank (E) on the frame.
Make sure that the 4 rubber blocks (E6) and the 2 spacers (E7)
are still present on tank (E).
Start no. 2 screws (E5), and tighten to the specified torque.
Fit clamp (K5) onto breather pipe (K6).
Reconnect breather pipes (K6) and (K7) to tank plug.
Reconnect connector (J2) to socket (K4) on fuel pump.
Tighten and press flange (K2) and fit fuel pipe (K3) inside fuel
pump.
Reconnect connector (Q1) of Bluetooth control unit to Bluetooth
wiring branch (J1).
Working on the right side of the motorcycle, fit RH side plate (N)
on tank support (V) and start no.2 screws (N1).
Tighten the no.2 screws (N1) to the specified torque.
Repeat the same procedure to refit LH side plate (P).
ISTR 607 / 01
Installing the original components (Multistrada
versions)
Refitting the tank
Refit the sounddeadening panel (T1) and soundproofing cover (T2)
to the bike.
Reposition the tank (E) on the frame.
Make sure that the 4 rubber blocks (E6) and the 2 spacers (E7)
are still present on tank (E).
Start no. 2 screws (E5), and tighten to the specified torque.
Fit clamp (K5) onto breather pipe (K6).
Reconnect breather pipes (K6) and (K7) to tank plug.
Reconnect connector (J2) to socket (K4) on fuel pump.
Tighten and press flange (K2) and fit fuel pipe (K3) inside fuel
pump.
Reconnect connector (Q1) of Bluetooth control unit to Bluetooth
wiring branch (J1).
Working on the right side of the motorcycle, fit RH side plate (N)
on tank support (V) and start no.2 screws (N1).
Tighten the no.2 screws (N1) to the specified torque.
Repeat the same procedure to refit LH side plate (P).
37
Publicidad
