Publicidad
Refitting the tank side covers
Fit no.3 washers (D2) on no.3 screws (D1).
Position RH tank cover (D) on tank (E) fitting pin (D5) inside
vibration damper (E1) and secure it by starting no.3 screws (D1) in
the positions shown in the figure.
Tighten no.3 screws (D1) to the specified torque.
Start no.3 screws (D4) and no.2 screws (D3) in the positions
shown and tighten them to the specified torque.
Repeat the same procedure to reassemble LH tank cover.
40
Refitting the tank side covers
Fit no.3 washers (D2) on no.3 screws (D1).
Position RH tank cover (D) on tank (E) fitting pin (D5) inside
vibration damper (E1) and secure it by starting no.3 screws (D1) in
the positions shown in the figure.
Tighten no.3 screws (D1) to the specified torque.
Start no.3 screws (D4) and no.2 screws (D3) in the positions
shown and tighten them to the specified torque.
Repeat the same procedure to reassemble LH tank cover.
ISTR 607 / 01
Publicidad
