because water proximity presents risk, even if the device is turned off.
18. Do not allow the device or power adaptor to wet. If the device falls into water,
immediately remove the power plug or power adaptor from the socket. If the device is
powered, do not put hands in the water. Have the device checked by the qualified
electrician before using it again.
19. Do not touch the device or power adaptor with wet hands.
20. The device has to be turned off after every use.
21. In order to provide additional protection, it is recommended to install residue current
device (RCD) in the power circuit, with residual current rating not more than 30 mA.
Contact professional electrician in this matter.
22. Do not block air inlet and outlet
23. Do not wrap the cord around the appliance.
24. Hair styler heats while is working. Do not touch the hot surface.
25. Never use sharp tools to clean the device.
PRODUCT DESCRIPTION (pic. 1)
1 – cool tip
2 – brush
4 – handle
5 - On/Off/temperature adjustment switch
6 - air inlet
7 - swivel cord
USING THE DEVICE
1. Plug hair styler into the mains socket.
2. Turn on hair styler with switch (5). Adjust required air temperature (1 - cool shot, 2 - lower temperature and speed, 3 - higher
temperature)
3. Separate streak of hair. Move brush (2) steadily across the each section from the scalp till the tips of the hair. Let the hot air pass
through the hair. Remember to direct air flow at hair not scalp. If you have thicker hair you would need to repeat this point until you get
suitable effect.
4. When you get expected outcome turn off hair styler by changing position of the switch to OFF(5)
5. Unplug from the socket.
NOTE: To avoid over drying, don't concentrate heat on one section for a long time. Keep the brush (2) moving while styling.
IMPORTANT: Do not cover air inlet (6) during styling.
CLEANING AND MAINTENANCE
1. Unplug hair styler from the power socket before cleaning.
2. Wipe the handle (4) with damp cloth. Do not use abrasive or sharp materials.
3. Clean brush (2) from hair after each use.
4. Check if the air inlet cover (6) is not stuck with hair or other dirt. If necessary clean it out.
TECHNICAL DATA
Power: 1200W
Voltage: 230V~50/60Hz
Please transfer cardboard packaging to waste paper. Pour the polyethylene bags (PE) into the plastic container
Worn device should be returned to the appropriate point storage because it is dangerous in the device
ingredients may pose a threat to the environment. The electrical device should be handed over to limit
its reuse and use. If in the device there are batteries you have to take out and give to the point stored separately.
ALLGEMEINE SICHERHEITSBEDINGUNGEN. WICHTIGE ANWEISUNGEN ZUR
VERWENDUNG DER SICHERHEIT
BITTE LESEN SIE SORGFÄLTIG DURCH UND BEWAHREN SIE DIE ZUKÜNFTIGE
VERWEISE AUF
Die Garantiebedingungen sind unterschiedlich, wenn das Gerät für kommerzielle Zwecke
3 – ceramic barrel
(DE) DEUTSCH
4