weasy LIN220 Manual De Instrucciones página 9

Defects and repairs
Do not attempt to replace a defective mains lead .The appliance has to be returned to an
authorized service centre for repair.
Faults-reasons and solutions
Iron emits an odor or smoke
Iron gives off an odor when turned on for the first time. Oils used during manufacture need to
be burnt off allow ten minutes for odor to disappear.
Iron does not heat
The iron should be plugged into a 230 Volt , Whether the power switch is turned on
Iron does not steam
The water tank many be empty. Turn the steam valve to "0" and add water .Allow the iron to
heat, and then set the steam dial to the steam setting.
"how to fill the water tank".
Iron is leaking
The variable steam dial must be set on" 0",until the iron is hot . The temperature setting is too
low to produce steam. Shot of steam used too much, allow iron to re-heat.
DISPOSAL
As a responsible retailer we care about the environment. As such we urge you to
follow the correct disposal procedure for the appliance and packaging materials.
This will help conserve natural resources and ensure that it is recycled in a manner
that protects health and the environment.
You must dispose of this appliance and its packaging according to local laws and
regulations.
Because this appliance contains electronic components, the appliance and its accessories
must be disposed of separately from household waste when the appliance reaches its end of
life.
Contact your local authority to learn about disposal and recycling.
The appliance should be taken to your local collection point for recycling. Some collection
points accept appliance free of charge.
Adeva SAS / H.Koenig Europe - 8 rue Marc Seguin - 77290 Mitry Mory - France
www.hkoenig.com - sav@hkoenig.com - contact@hkoenig.com - Tél : +33 1 64 67 00 05