Operating System Recovery - Bosch DCU 100 Manual Original

en | 24 | DCU 100 | Restoring the operating system (recovery)
Procedure
!
All data and programs on the USB stick will be
erased during the process of creating a bootable
recovery USB stick.
i
Administrator rights are required for creating a
bootable recovery USB stick!
i
In the following description of the creation of a
bootable recovery USB stick, the open-source soft-
ware "Rufus" is used as an example.
1. Download software for creating a bootable USB stick, e.g.
"Rufus" (https://rufus.ie).
2. Install the "Rufus" software.
3. Insert the USB stick into the computer.
4. Launch the "Rufus" software.
5. Under "Drive," select the USB stick as the target
medium.
6. Select<SELECTION>.
7. Select the desired image.
8. Select the "GPT" partitioning scheme and "UEFI
(non CSM)" target system.
i
Under "Drive name," the recovery USB stick can be
given a different name.
9. Select <START>.
10. Use <OK> to acknowledge the warning about losing
the data saved to the selected USB stick.
"
A bootable recovery USB stick will be created (dura-
tion: approx. 1 h).
|
1 689 989 283 2021-01-24
7.4

Operating system recovery

!
All data and programs on the hard drive will be
erased during the recovery process.
1. Use the power supply unit to supply the DCU 100
with power.
2. Connect a keyboard to the USB port of the DCU 100.
3. Insert the recovery USB stick into the USB port of
the DCU 100.
4. Switch the DCU 100 on.
 The following message will be displayed:
very System
.
5. Select <OK>.
 The following message will be displayed:
you really want to recover your Com-
puter?
6. Select <Yes>.
 The following message will be displayed:
NING! ALL DATA ON HARD DISK DRIVE C:
WILL BE LOST. Please be patient while
recovery process is running. Proceed
with recovering?
7. Select <Yes>.
 The recovery will be started (duration: approx.
40 min). The following message will be dis-
Press any key to continue.
played:
8. Press any key.
9. Remove the recovery USB stick.
10. Press E.
 The DCU 100 will be shut down.
11. Switch the DCU 100 on.
 Windows will launch and begin initial commissi-
oning.
12. Read and follow the instructions on the screen.
13. Remove the USB keyboard.
"
The recovery is complete.
14. Install and perform the licensing process for
ESI[tronic] 2.0 (optional).
Reco-
Would
WAR-
Robert Bosch GmbH