Care And Cleaning; Service And Customer Care - Kenwood JKP250 Instrucciones

care and cleaning

Before cleaning, unplug your kettle
G
and let it cool down.
The cups and spoons can be placed
G
in the kettle for compact storage.
Wrap the cord around the kettle and
G
secure using the cord clip
the outside
Wipe with a damp cloth, then dry. Do
G
not use abrasives - they will scratch
the plastic surfaces.
the inside
Even though your kettle comes with
G
a filter, you still need to clean the
inside (and the filter) regularly.
the filter
1 To open the lid, pull back the lid
release catch
2 Unclip and slide out the filter
3 either rinse under the tap or use a
soft brush.
or when descaling your kettle, drop
the filter in too. Rinse thoroughly.
4 Replace the filter by locating the front
of the filter into the spout area and
then clip into place
descaling
Regular descaling of the flat element
G
will improve the performance of your
kettle. If the kettle is not descaled
regularly the build up of limescale
may result in the following:
problems may be experienced
G
with the kettle switching on and off
during use or switching off before
boiling.
the kettle may take longer to boil.
G
the flat element may be damaged.
G
.
.
.
.
Please note: Failure to descale your
kettle may invalidate your guarantee.
When limescale starts to build up on
G
the heating element, buy a suitable
descaler and descale your kettle.
After descaling, boil with fresh water
several times and discard. Clean any
descaler off the kettle - it can
damage the parts.
Some regions of the country have
G
chalky water. This makes boiled
water look cloudy and leaves a
deposit on the side of the kettle. This
is normal but can be removed with
regular cleaning.
Alternatively, to reduce limescale
G
build up, use filtered water to fill your
kettle.
service and customer
care
If the cord is damaged it must, for
G
safety reasons, be replaced by
KENWOOD or an authorised
KENWOOD repairer.
If you need help with:
using your appliance or
G
servicing or repairs
G
Contact the shop where you bought
your appliance.
Designed and engineered by
G
Kenwood in the UK.
Made in China.
G
4