B Loading The Salt Into The Softener; C Fill The Rinse Aid Dispenser - Blaupunkt 5VT710NA Manual De Montaje Y Modo De Empleo

B� Loading the Salt Into the Softener
Always use the salt intended for use with dishwasher.
The salt container is located beneath the lower basket and should be fi lled as explained in the following:
Attention!
Only use salt specifi cally designed for the use in dishwashers! Every other type of salt not specifi cally
designed for the use in a dishwasher, especially table salt, will damage the water softener. In case of
damages caused by the use of unsuitable salt the manufacturer does not give any warranty nor is liable for
any damages caused.
Only fi ll with salt just before starting one of the complete washing programs.
This will prevent any grains of salt or salty water, which may have been spilled, remaining on the bottom of
the machine for any period of time, which may cause corrosion.
1
Open
After the lower basket has been removed, unscrew and remove the cap from the salt container.
A
Place the end of the funnel (supplied) into the hole and introduce about 1.5kg of dishwasher salt.
B
Full fi ll the salt container with water, It is normal for a small amount of water to come out of the salt
C
container.
D
After fi lling the container, screw the cap tightly back clockwise.
The salt warning light will stop being after the salt container has been fi lled with salt.
E
Immediately after fi lling the salt into the salt container, a washing program should be started (We suggest
F
to use a short program). Otherwise the fi lter system, pump or other important parts of the machine may be
damaged by salty water. This is out of warranty.
NOTE:
1. The salt container must only be refi lled when the salt warning light in the control panel comes on. Depend-
ing on how well the salt dissolves, the salt warning light may still be on even though the salt container is
fi lled.
If there is no salt warning light in the control panel (for some Models), you can estimate when to fi ll the salt
into the softener by the cycles that the dishwasher has run.
2. If there are spills of the salt, a rapid program should be run to remove the excessive salt.
C� Fill the Rinse Aid Dispenser
Rinse Aid Dispenser
The rinse aid is released during the fi nal rinse to prevent water from forming droplets on your dishes, which can leave spots
and streaks. It also improves drying by allowing water to roll off the dishes. Your dishwasher is designed to use liquid rinse
aids. The rinse aid dispenser is located inside the door next to the detergent dispenser. To fi ll the dispenser, open the cap and
pour the rinse aid into the dispenser until the level indicator turns completely black. The volume of the rinse aid container is
about 110ml.
Function of Rinse Aid
Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying.
Attention!
Only use reliable rinse aid for dishwasher. Never fi ll the rinse aid dispenser with any other substances (e.g. Dishwasher
cleaning agent, liquid detergent). This would damage the appliance.
2
38
1
2