Benjamin FAH001 Manual De Instrucciones

CO Fill Adapter
2
MODEL FAH001
READ ALL INSTRUCTIONS AND WARNINGS IN THIS
MANUAL BEFORE USING THIS AIRGUN
Always wear eye protection when working with compressed gas! Venting gas can and does accelerate par-
ticles of dirt and debris to high velocity. Keep all persons without eye protection out of the immediate area!
The FAH001 CO Fill Adapter connects generic refillable CO
2
Pre-charged Pneumatic (PCP) airguns.
Read all instructions carefully before use.
WARNING:
: Keep all Petroleum lubricants away from parts of the FAH001 Fill
Adapter. Petroleum lubricants may cause fire or explosion if entered into the high pres-
sure tube in your Benjamin PCP airgun.
Always wear eye protection when working with compressed gas! Venting gas can and does accelerate par-
ticles of dirt and debris to high velocity. Keep all persons without eye protection out of the immediate area!
Always wear gloves to protect your hands from extreme cold. The action of venting a CO
temperatures as low as –130°f. Immediate and destructive freezing of exposed flesh is possible.
1.0 Operation
WARNING:
: This fill adapter will vent gases stored under high pressure. Make cer-
tain the valve is closed (turned fully counter-clockwise) before connecting to a CO
1.1 Close the valve (part #1) by turning the knob (part #2) fully counter-clockwise.
1.2 Screw the valve onto the fill bottle making certain all components are clean and dry. Tighten securely by
hand only. DO NOT use tools to tighten.
1.3 Connect the fill adapter quick disconnect socket to the fill nipple on the Benjamin PCP airgun (make sure
connection is secure).
1.4 Invert the bottle. Open the valve slowly by turning the valve knob in a clockwise direction. You should
hear the airgun filling with CO . A complete fill should take approximately 1 minute.
2
1.5 Check the airgun pressure gauge. The gauge should read approximately 900 PSI.
1.6 Upon completion of filling, close the fill adapter valve by turning the knob completely in a
counter-clockwise direction.
WARNING:
: In the following procedure, CO
valve when relieving pressure from the fill hose. Use caution in directing the venting
CO . Always wear gloves and safety glasses!
2
1.7 Twist the CO bottle from the Fill Adapter valve slowly until the CO
2
small venting hole (part #5) in the valve positioned below the fill hose. .
1.8 Upon completion of CO venting from the valve, remove the bottle completely from the fill adapter valve.
2
Distributed by
Crosman Corporation
7629 Routes 5 & 20
E. Bloomfield, NY 14443
1-800-7AIRGUN (724-7486)
www.crosman.com
bottles (with .825-14 NGO Thread) to Benjamin
2
P/N FAH001-515
bottle can produce
2
PARTS LIST
1 – Valve
2 – Valve knob
3 – Hose
4 – Quick Disconnect
5 – Vent Hole
bottle.
2
will rush out of the vent hole in the
2
trapped in the hose vents from the
2
1.9 Disconnect the fill adapter from the airgun.
2.0 Maintenance and Care of the FAH001 Fill Adapter
• Keep the fill adapter clean and dry.
• The fill adapter requires no other periodic maintenance
Keep all Petroleum lubricants away from parts of the FAH001 fill adapter. Petroleum lubricants may cause fire
or explosion if entered into the high pressure tube in your Benjamin PCP airgun.
LIMITED 90 DAY WARRANTY
This product is warranted to the retail consumer for 90 days from date of retail purchase against defects in
material and workmanship and is transferable. You should retain the original sales receipt as record of date of
purchase.
WHAT IS COVERED
Replacement parts and labor. Transportation charges to consumer for repaired product.
WHAT IS NOT COVERED
Transportation charges to Crosman Corporation. Damages caused by abuse, modification or failure to
perform normal maintenance. Any other expense. CONSEQUENTIAL DAMAGES, INCIDENTAL DAMAGES,
OR INCIDENTAL EXPENSES INCLUDING DAMAGE TO PROPERTY. SOME STATES DO NOT ALLOW THE
EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE LIMITA-
TION OR EXCLUSION MAY NOT APPLY TO YOU.
HOW TO OBTAIN WARRANTY PERFORMANCE
Call Crosman customer service at 800-724-7486 for details on how to proceed with sending the item in for
repair. You must contact Crosman prior to shipping your product.
IMPLIED WARRANTIES
ANY IMPLIED WARRANTIES INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FIT-
NESS FOR A PARTICULAR PURPOSE ARE LIMITED IN DURATION TO ONE YEAR FROM DATE OF RETAIL
PURCHASE. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY
LASTS SO THE ABOVE LIMITATIONS MAY NOT APPLY TO YOU.
To the extent any provision of this warranty is prohibited by federal, state or municipal law, which cannot be
preempted, it shall not be applicable. This warranty gives you specific legal rights and you may also have
other rights, which vary, from state to state.
Crosman® and Benjamin® are registered trademarks of Crosman Corporation in the United States.