Intended Use; Safety Instructions; General Power Tool Safety Warnings - Black+Decker MTS12 Manual Del Usuario

ENGLISH

Intended use

Your Black & Decker multi-purpose tool has been
designed for a wide range of DIY applications.
Using the shear head (MTS12), this tool is
intended for cutting thin, flexible materials, such as
carpet (up to 6.5mm), vinyl, metal (up to 0.5 mm)
and wire mesh (up to 0.5 mm).
This tool is intended for consumer use only.

Safety instructions

General power tool safety warnings

@
Warning! Read all safety warnings
and all instructions. Failure to follow
the warnings and instructions listed
below may result in electric shock, fire
and/or serious injury.
@
Warning! Read all safety warnings
and all instructions provided with your
power tool (MT143, MT350, MT108
or MT18) before using this accessory.
Failure to follow the warnings and in-
structions may result in electric shock,
fire and/or serious injury.
4
(Original instructions)
Save all warnings and instructions for future
reference. The term "power tool" in the warnings
refers to your mains operated (corded) power tool
or battery operated (cordless) power tool.
@
Warning! Additional safety warnings
for shears and nibblers
Hold power tool by insulated gripping sur-
u
faces when performing an operation where
the cutting accessory may contact hidden
wiring. Cutting accessory contacting a "live"
wire may make exposed metal parts of the
power tool "live" and could give the operator an
electric shock
Use clamps or another practical way to se-
u
cure and support the workpiece to a stable
platform. Holding the work by hand or against
your body leaves it unstable and may lead to
loss of control.
Keep hands away from cutting area. Never
u
reach underneath the work piece for any
reason. Do not insert fingers or thumb into the
vicinity of the blade. Do not stabilize the shear
by gripping underneath.
Keep blades sharp. Dull or damaged blades
u
may cause the saw to swerve or stall under
pressure. Always use the appropriate type of
saw blade for the workpiece material and type
of cut.