Switching On And Off - Black+Decker MTS12 Manual Del Usuario

Do not touch the workpiece or the blade
u
immediately after operating the tool. They can
become very hot.
The blade will continue to move after releasing
u
the switch. Always switch the tool off and
wait for the saw blade to come to a complete
standstill before putting the tool down.
@
Warning! Contact with, or inhalation
of dusts arising from cutting applica-
tions may endanger the health of the
operator and possible bystanders.
Wear a dust mask specifically
designed for protection against dust
and fumes and ensure that persons
within or entering the work area are
also protected.
The intended use is described in this instruc-
u
tion manual. The use of any accessory or
attachment or performance of any operation
with this tool other than those recommended
in this instruction manual may present a risk of
personal injury and/or damage to property.
Features (fig. A)
Tool shown is MT218. Other tools are available for
use with this tool head.
This tool includes some or all of the following
features.
(Original instructions)
10. Shear head
11. Upper blade
12. Lower blade
Use
Warning! Let the tool work at its own pace. Do not
overload.

Switching on and off

Note: Ensure the forward reverse slider (2) is not
in the locked position.
To switch the tool on, press the variable speed
u
switch (1). The tool speed depends on how far
you press the switch.
To switch the tool off, release the variable
u
speed switch.
Materials that can be cut
Carpet up to 6.35mm thick.
u
Fabric.
u
Vinyl (flexible plastic) up to 3.175mm thick.
u
Metal 26 GA (0.5mm) or thinner.
u
Wire mesh 0.5mm or thinner.
u
Note: Do not use this tool for pocket cutting.
Cutting metal (fig. B)
Only thin guage metals (26 GA or thinner) are
u
to be cut.
ENGLISH
5