DAYTEK MK 2 Manual De Instrucciones página 10

HOW TO RESTRING/REPLACE THE LINE ON YOUR DAYTEK ROTARY CLOTHESLINE
ARM 3
ARM 2
A. Tensioner Block Bottom –
recessed into the arm of the
clothesline.
B. Tensioner Block Top –
positioned on top of the
bottom block.
TO REPLACE A LINE ON YOUR DAYTEK ROTARY
CLOTHESLINE, YOU MUST REMOVE THE TENSIONER
BLOCK TOPS OFF THE AFFECTED LINE.
To remove the Tensioner Block Tops
1. Place your index finger on top of the Tensioner
Block and over the Nut to ensure that the Nut is
held in position.
2. Undo and loosen the bolt from under the arm of
the clothesline. Once the bolt is fully loose, you can
carefully remove the Tensioner Block Top & Nut.
C. Bolt – head of bolt under
the arm of the clothesline.
D. Nut – seated in the top of
the line tensioner.
3. Remove the line from the Tensioner Block.
4. Work your way around the clothesline
removing all four Terminal Blocks Tops
and the line.
10
ARM 4
ARM 1 – LINE END
D
B
A
C