Technical Data; Noise/Vibration Information; Declaration Of Conformity - Bosch GNA 3,5 Professional Manual Original

OBJ_BUCH-101-002.book Page 13 Tuesday, October 9, 2007 9:18 AM
8 Borehole at die holder
9 Screw for die
10 Punch
11 Guide plate
12 Hold down guide
13 Screw for hold down guide
14 Die
15 Die holder
16 Die adjustment screw
The accessories illustrated or described are not includ-
ed as standard delivery.

Technical Data

Nibbler
Article number
Rated power input
Output power
Stroke rate at no load n
0
Stroke speed under
load
Max. steel sheet cutting
capacity*
Cutting width
Smallest curve radius
Weight according to
EPTA-Procedure
01/2003
Protection class
2
* to 400 N/mm with reference to steel sheet
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.

Noise/Vibration Information

Measured values determined according to
EN 60745.
Typically the A-weighted sound pressure level of
the product is 80 dB(A). Uncertainty K=3 dB.
The noise level when working can exceed 80 dB(A).
Wear hearing protection!
Bosch Power Tools
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Vibration emission value a
K < 1.5 m/s
The vibration emission level given in this informa-
tion sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different applications, with differ-
ent accessories or poorly maintained, the vibra-
tion emission may differ. This may significantly
GNA 3,5
increase the exposure level over the total work-
Professional
ing period.
0 601 533 1.. An estimation of the level of exposure to vibra-
tion should also take into account the times
W 620
when the tool is switched off or when it is run-
W 340
ning but not actually doing the job. This may sig-
spm 1000
nificantly reduce the exposure level over the total
working period.
Identify additional safety measures to protect the
spm 670
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
mm 3.5
hands warm, organisation of work patterns.
mm 6
mm 70

Declaration of Conformity

We declare under our sole responsibility that the
kg 3.5 product described under "Technical Data" is in
conformity with the following standards or
/ II
standardization documents: EN 60745 according
to the provisions of the directives 2004/108/EC,
98/37/EC (until Dec. 28, 2009), 2006/42/EC
(from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
20.08.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
English | 13
2
= 9 m/s , Uncertainty
h
2
.
Dr. Eckerhard Strötgen
Head of Product
Certification
1 609 929 M47 | (9.10.07)