Uline TORK H-7544 Guia De Inicio Rapido página 3

1. Remove core from center of roll. Find end of
cardboard, peel corner up and pull straight up. First
sheet of paper will be attached to core. Tear sheet
off and dispose of core. (See Figure 10)
Figure 10
2. Place roll on top of towel tray inside dispenser.
Angle the bottom of the roll and feed first sheet into
oval hole in tray. Push towel down between rollers of
dispensing assembly. (See Figure 11)
3. Seat roll on tray, ensuring towel stays between
rollers of dispensing assembly. (See Figure 11)
Figure 11
The dispenser should be cleaned any time there is
heavy paper dust buildup inside of it.
NOTE: If paper dust buildup is not a problem,
approximately every year is a good frequency
for cleanings.
The following is the recommended procedure for
cleanings:
1. Open the dispenser and remove the roll of paper.
Clear all paper from the dispenser assembly.
PAGE 3 OF 12
LOADING
4. Close dispenser cover.
(See Figure 12)
5. Advance paper tail through
dispensing assembly by
turning knob on bottom right
of dispenser in a clockwise
motion. (See Figure 13)
Figure 13
MAINTENANCE
2. Clean out any paper dust. This can be done by
vacuuming, blowing out with can of compressed air
(wearing safety glasses) or wiping out with a damp
cloth.
3. Clean cover with a gentle cloth and an
all-purpose cleaner that is safe for plastics. It is not
recommended that paper be used to clean that
surface of the dispenser as it may scratch the high-
gloss surface.
Figure 12
0721 IH-7544