Uline H-5181 Manual Del Usuario página 2

3. Insert and slide aluminum tubes through top and
bottom holes of panels. Center panel onto tubes.
Nut holes should face up. (See Figures 3-4)
Figure 3
Figure 4
4. Slide plastic connectors onto ends of top and
bottom tubes and secure using bolts and nuts
provided. Ensure the connector pegs are facing up
for the upper tube and down for the lower tube on
both ends of the panel/tube assembly.
(See Figure 5)
PAGE 2 OF 9
INSTALLATION CONTINUED
Figure 5
Connector
Peg
Connector
Peg
5. Insert bottom plastic connector pegs into the holes
of the bases and position top plastic connectors into
posts. (See Figure 6)
Figure 6
CAUTION! Do not assemble more than three
panels between two posts.
To add another straight section of fence, repeat
steps 2-5 as needed.
6. For right angle fence
assembly, rotate the
corner post 45º before
installing the next section
of panels. (See Figure 7)
7. Fill each post and base with water, sand or any
other granular material as needed. (See Figure 8)
Figure 8
Hole
Figure 7
Hole
1220 IH-5181