Tabla de contenido
Publicidad
ASSEMBLY
1.
Insert the Paper Guides into the Paper Tray as shown in Figure 1. You will need to remove the black
plastic nuts and clear spacers from the Guides. Once inserted, install the clear spacers on the Paper
Guides and screw the nuts back onto the Paper Guides and tighten. The Paper Guides should now be
attached to the machine as shown in Figure 2.
2. To assemble the Exit Tray, you will need a #2 Philips screwdriver, the 2 Metal Brackets, and the
(3) Exit Tray Connector Sets (each set contains one top plastic piece, one bottom plastic piece, and
two screws). Assemble each Exit Tray Connector Set onto the Metal Brackets as shown in Figure 3.
Hint: It may be easier to assemble the middle Connector Set first, as noted below.
3. The assembled Exit Tray should fit underneath the machine (Figure 4). It does not snap into place,
the weight of the machine will hold it in position. Push the Tray so it is against the tabletop. Many
users find it easier to attach the first connector to (1) metal part and screw halfway together. The
other metal portion may then be installed to the plastic connector and screwed together completely.
Figure 3
4.
Insert the plug into the back of the machine, and then into an electrical outlet.
ALIGNING THE PAPER GUIDES
NOTE: Paper guide placement is a critical and often overlooked factor in machine set-
up. Please follow the instructions below carefully to assure trouble free paper feeding.
1. Loosen the 4 plastic thumbscrews under the feed table (see figure #1 for thumbscrew location) to loosen
paper guides.
2. For standard U.S. 8 1/2" X 11" paper, move both paper
guides in so that their inside edges align with the straight
marks on the feed table denoted LS (see figure 5 for mark
location). For A4 paper, Align the outside edges of the
paper guides with the straight marks denoted A4. Tighten
both thumbscrews (Note: Do not overtighten thumbscrews).
3. Slide a single piece of paper between the paper guides,
check for:
a. Pinching-the paper should slide freely between the
paper guides with a small amount of clearance to feed freely.
Loosen thumbscrews and adjust paper guides if necessary to
correct. Setting the paper guides too tight will result in feed hesitation.
b. Skewing-the paper should be exactly square to the feeding roller. Loosen thumbscrews and adjust
paper guides if necessary to correct.
Assemble this Set first
Figure 1
LS
Figure 2
Figure 4
Position this set near the
front of the Exit Tray for
better stacking
Figure 5
Paper Guides Aligned to LS Marks
LS
Publicidad
Tabla de contenido
