Tabla de contenido
Publicidad
Note: Paper is placed in folder
square. Paper is not fanned
HAND FEEDING OF SETS (Mandatory when folding multiple sheet sets of paper)
1.
To prevent jams, remove all paper from the Paper Tray before feeding sets by hand.
2.
For feeding sets of up to 3 sheets (stapled or unstapled), first square the paper against a tabletop.
3.
Place the paper into the manual feed slot on the top of the machine (as shown in Figures 13 and 14).
Do not install multiple sheet sets in the Feed Table, a jam will result.
4.
Use the momentary on, "II" switch position to initiate folding. Hold switch down until folded paper exits
machine.
5.
Do not run machine for long periods of time without paper in the Paper Tray, this could wear down the feed tire.
HINT: For multiple sheet sets of paper, creasing of the stock may be encountered due to the thickness
of the multiple sheet set. Correct by moving the 1st fold table stop out approximately 1/8". For example,
if the 1st fold table is set at 7 3/8" for a letter fold, the user would reset it to 7 1/2" for the multiple sheet
set.
PAPER JAMS
1.
Unplug the machine. Check to see if you can clear the jam by removing one of the Fold Tables.
2.
If you can not remove the jam, use a flathead screwdriver to manually turn the folding rollers, using the
access hole in the left side of the machine. The paper should eventually emerge from the machine.
3.
You may need to remove the top plastic cover to extract the jammed paper.
TROUBLESHOOTING
PROBLEM: The paper jams in the machine.
SOLUTION: 1. If feeding by hand, make sure that there is no paper in the Paper Tray.
2. Re-align the Paper Guides and check Fold Table settings.
3. Check to see if paper is within specifications (8
4. Remove top cover and clean rollers with Martin Yale Rubber Roller Cleaner (model 200).
5. Use Martin Yale Static Eliminator (model 300) to remove static in paper.
PROBLEM: Paper will not feed correctly.
SOLUTION: 1. Paper guides too tight or not parallel to each other, Adjust paper guides as described in
Aligning the Paper Guides section of this instruction manual.
1. If feeding by hand, make sure the paper is properly aligned before placing it in the slot.
2. If feeding by hand, place the set in the slot before turning the machine on.
3. Re-align the Paper Guides.
4. Check to see if paper is within specifications (8
5. The feed tire could be worn. Replace.
Figure 13
Side view of paper loaded
Use Martin Yale Rubber
Figure 14
Roller Cleaner (model 200) for
better folding performance
" x 11" or A4, 16-28 lb. bond or 60-105 gsm).
1/2
" x 11" or A4, 16-28 lb. bond or 60-105 gsm).
1/2
Folder feeds the top sheet.
Only the top sheet of paper
should be in contact with
feed wheel
Manual feed slot used for
multiple sheet sets of paper.
and longer roller life.
Publicidad
Tabla de contenido
