ketrop The Hunter 040 Instrucciones De Montaje Y Uso página 3

4
5
WWW.VOGELVERSCHRIKKER.NL | WWW.KETROP.COM
ASSEMBLY AND USE
4. Add the stainless steel barrel to the assembly by
slotting in the tubular barrel onto the man where it is
slotted and securing with the nut and bolt supplied.
5. You should now have the two complete parts ready
to take to the site where your Hunter will be on patrol!
Assembly is simply a matter of sliding the tube section
of the man over the bearing and shaft assembly.
Press the shaft into the ground using the large diameter
Hunter base. Ensure that the shaft is upright by moving
your foot position as needed. The closer the Hunter is to
being upright the better it will move in the wind.
For added realism,
if required, change
the colours each
season to keep the
birds guessing;
some ideas above.
Use any waterproof
paint and your
imagination!
Part No. 040