Troubleshooting - Huskie Tools 45202 Manual De Instrucciones

Troubleshooting

Concrete or block wall installation
□ To install over concrete or cinder block, fasten 2 x 3 in.
studs or furring strips to your walls using tap cons or other
specialty fasteners first, then proceed to install Husky
Track Wall Panels as per the Assembly Instructions.
Vertical configuration installing
more than 4 ft. high
□ If you are installing more than one section vertically, cut
vertical J-trims to desired height and continue panel
installation.
□ Do not add additional trim between sections
for optimum results.
Section 1
No J-trim
Section 2
16 in.
24 in. stud centers
□ Husky
Track Wall panels are designed to hold 75 lbs per
®
square foot when installed as directed in studs spaced
16 in. apart. If your studs are wider apart, apply some
adhesive to the back of the panel if installing over drywall.
Horizontal Configuration
□ Installing 2 sections – 16 ft. wide x 4 ft. high
Section 1
Use two J-trims, back-to-
back between sections .
Section 2