Closing The Door - IKEA NUMRERAD Manual Del Usuario

Ocultar thumbs Ver también para NUMRERAD:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH
Problem
The temperature in the appliance
is too low/too high.
There is too much condensed
water on the rear wall of the
refrigerator.
Water flows inside the
refrigerator.
Water flows on the floor.
The door does not close
completely.
If your appliance still is not working
properly after making the above checks,
contact the Authorised Service Centre. You
can find the list at the end of this manual.
Possible Cause
The temperature is not set correctly.
The door is not closed correctly.
The wine bottles temperature is too
high.
Many wine bottles are inserted at the
same time.
The door has been opened often.
There is no cold air circulation in the
appliance.
Door was opened too frequently.
Door was not closed completely.
The drain hole at the back of the
appliance is clogged.
Wine bottles prevent water from flowing
to the drain hole at the back of the
appliance.
The door is not closed well.
The appliance tilts forward.
The drip pan cracks.
The defrost water drain is clogged.
The shelves are out of position.
The door gaskets are dirty.
The appliance is not level.

Closing the door

1.
2.
3. If necessary, replace the defective door
Set a higher/lower temperature.
Refer to "Closing the door".
Let the wine bottles temperature
decrease to room temperature
before storage.
Insert fewer wine bottles at the
same time.
Open the door only if necessary.
Make sure that there is cold air
circulation in the appliance.
Open the door only when
necessary.
Make sure the door is closed
completely.
Clean the drain hole with a piece
of wire.
Make sure that wine bottles do not
touch the rear plate.
Refer to "Closing the door", or
refer to the troubleshooting item
below ("The door does not close
completely").
Tilt the appliance slightly backward
(a quarter-inch lower in the back).
Refer to the separate Assembly
Instructions for appliance level
adjustment.
Contact Authorised Service Centre
listed at the end of this manual.
Clean the drain hole with a piece
of wire.
Make sure the shelves are in
correct position. Refer to "Movable
shelves".
Clean the door gaskets. Refer to
"Care and cleaning".
Make sure the appliances
is installed in level. Refer to
"Levelling feet", or the separate
Assembly Instructions.
Clean the door gaskets.
If necessary, adjust the door. Refer to the
separate Assembly Instructions.
gaskets. Contact the After Sales Service.
16
Solution

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido