Electrical Connection - IKEA NUMRERAD Manual Del Usuario

ENGLISH
components, including the refrigerant
tubes. Leaking refrigerant may ignite or
cause eye injuries.
• Do not use other means to accelerate
the defrosting process other than those
recommended by the manufacturer.
• Do not damage the refrigerant circuit.
• Do not store products which contain
flammable propellants (e.g. spray cans) or
explosive substances in the appliance. Risk
of explosion!
• Only store high-proof alcohol tightly closed
and standing up.
• Keep ventilation openings, in the appliance
enclosure or in the built-in structure, clear of
obstruction.
• Never cover or block the ventilation
openings for the appliance.
• Switch the appliance off prior to cleaning.
• Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads,
solvents or metal objects.
• Keep plastic parts and the refrigerator seal
free of oil and grease. Otherwise, parts and
the refrigerator seal will become porous.
• Do not stand on or lean heavily against the
base of the appliance, door, shelves etc.
Transportation
The appliance is heavy and must be handled
with caution during transportation and
installation. Because of the weight and
dimensions of the appliance, at least two
persons are necessary to move the appliance
into position securely and avoid injuries to
people or damage to the appliance.
Installation
Warning! Only a qualified person can
install this appliance.
• Remove all the packaging and the transit
bolts.
• Do not install or use a damaged appliance.
• Follow the installation instruction supplied
with the appliance.
• Always take care when moving the
appliance as it is heavy. Always use safety
gloves and enclosed footwear.
• Make sure the air can circulate around the
appliance.
• Do not tilt the refrigerator for more than 45°
form upright during moving it.
• At first installation or after reversing the
door wait at least 4 hours before connecting
the appliance to the power supply. This is to
allow the oil to flow back in the compressor.
• Before carrying out any operations on the
appliance (e.g. reversing the door), remove
the plug from the power socket.
• Do not install the appliance close to
radiators or cookers, oven or hobs.
• The rear of the appliance must stand
against the wall.
• Do not install the appliance where there is
direct sunlight.
• Do not install this appliance in areas that
are too humid or too colds, such as the
construction appendices, garages or wine
cellars.
• When you move the appliance, lift it by the
front edge to avoid scratching the floor.

Electrical connection

Warning! Risk of fire and electrical shock.
Warning! When positioning the appliance,
ensure the power cord is not trapped or
damaged.
Warning! Do not use multi-plug adapters
and extension cords.
Warning! Do not, under any
circumstances, cut, remove, or bypass the
grounding prong.
3-prong plug
Grounding pin
3-prong receptacle
Ground receptacle box
• The appliance must be earthed. The
appliance must be plugged into its own
dedicated 115 Volt, 60 Hz.,15 Amp, AC
only electrical outlet. The power cord of
the appliance is equipped with a 3-prong
grounding plug for your protection
against electrical shock hazards. It must be
plugged directly into a properly grounded
3-prong receptacle. The receptacle must be
7