Connecting An Swa-W500 (Sold Separately) - Samsung HW-S50A Manual

Connecting an SWA-W500 (Sold Separately)

1. Turn off the Soundbar by pressing the
2. Plug in the Wireless Subwoofer, and then check its standby status.
• Plug the Wireless Subwoofer power cord into an electrical outlet and into the Wireless
Subwoofer to turn on the Wireless Subwoofer. The LINK LED indicator (blue LED) on the
Wireless Subwoofer blinks. If the LED does not blink, press the ID SET button on the rear of the
Wireless Subwoofer with a pen tip for 5~6 seconds until the LINK LED indicator blinks (in Blue).
For more about the LED, please refer to the SWA-W500 user manual.
POWER
POWER ID SET
Rear of the Wireless Subwoofer
• The main unit is heavy. Be careful not to pinch your fingers when pressing the ID SET button or
connecting the power cord to the rear of the unit.
• The upper part of the subwoofer is prone to scratches. Handle it carefully.
Bottom of the Wireless Subwoofer
PAIR
SOUND
MODE
VOL WOOFER
SOUNDBAR
ID SET
Speaker Unit
(Power) button on the remote control.
Red Blinks X3
ID SET
POWER ID SET
5 Sec
POWER ID SET
POWER ID SET
ENG - 20
Blue blinking
Front of the Wireless Subwoofer
• Do not press on or strike the
Speaker Unit on the bottom of
the body. You can deform or
damage the speaker.